Sennheiser EM500 Music Mixer User Manual


 
12
To mount two receivers into a rack:
̈ Place the two receivers side by side onto a flat
surface, their bottom sides facing upwards.
̈ Align the connecting plate ƽ over the holes in the
bottom sides of the receivers.
̈ Secure the connecting plate ƽ to the receivers
using eight of the supplied recessed head screws
(M 3x6).
̈ Hook the two rack mount “ears” ƻ to the front
panels of the receivers.
̈ Secure the rack mount “ears” to the receivers using
two of the supplied recessed head screws (M 3x6)
respectively.
̈ Slide the receivers into the 19” rack.
̈ Secure the rack mount “ears” to the rack.
When mounting only one receiver into a rack, use the
connecting bar Ƽ instead of the second receiver.
̈ Hook the two rack mount “ears” ƻ to the front
panel of the receiver.
̈ Secure the rack mount “ears” to the receiver using
two of the supplied recessed head screws (M 3x6)
respectively.
̈ Secure the connecting bar Ƽ to one of the rack
mount “ears” ƻ using two of the supplied recessed
head screws (M 6x10).
̈ If you are not front mounting the antennas, insert
the two covering plugs ƾ into the antenna holes of
the connecting bar.
̈ Slide the receiver into the 19” rack.
̈ Secure the rack mount “ears” to the rack.
To mount the receiver’s telescopic antennas to the
front of the GA 2 rack adapter using the AM 2 antenna
mount:
̈ Screw the two BNC sockets ƿ of the BNC extension
cables to the connecting bar Ƽ using the supplied
plain washers and nuts.
̈ Connect the two BNC connectors to the BNC
sockets ¹ and ƹ at the rear of the receiver.
̈ Slide the receiver into a 19” rack.
̈ Secure the rack mount “ears” to the rack.
̈ Connect the two telescopic antennas ƺ to the two
BNC sockets ƿ.
̈ Pull the telescopic antennas out and align them
upwards in a V-shape.
ƻ
ƻ
ƽ
Ƽ
ƻ
ƻ
ƾ
ƿ
Ƽ
ƺ