Filter
Top Products
22
̈ Select the “Soundcheck” menu. The soundcheck is started immediately.
̈ With the transmitter, walk up and down the transmission area.
̈ Press the ̄ button on the receiver to terminate the soundcheck and to
display the result of the soundcheck. The level displays “RF” and “AF” will
indicate the lowest RF and the highest AF level of the received
transmitter.
Optimize the RF level by repositioning the receiving antennas.
The audio level should be as high as possible (max. 0 dB) without the level
display for audio signal “AF” showing full deflection (see the section
“Adjusting the sensitivity“ in the operating manual of the transmitter).
If both receiving antennas are connected and aligned, the diversity
displays I and II appear on the display panel.
If no transmitter is being received, the “MUTE” display appears on the
display panel.
̈ To do another soundcheck (e.g. with an improved antenna arrangement,
another transmitter position or a new transmitter sensitivity), press the
̆ button.
Selecting the standard display
Display
Via the “Display” menu, you can select the standard display:
Selectable standard display Contents of the display
“Main”
(standard display)
“Frequency”
(display of the frequency)
“Bank/Channel”
(display of the channel bank and
channel number)
“Name”
(display of the freely selectable
name)
“AF meter”
(graphic display of the AF level)
“Second RF”
(display of the RF levels of the two
diversity sections)