Filter
Top Products
10
Putting the radio microphone into operation
Inserting batteries into the B 5000-2 battery box
LC display shown on the example of the B 5000-2 battery box
Recharging the BA 5000-2 battery pack
Before using the BA 5000-2 battery pack (see “ Accessories” on page 30)
for the first time or if you have not used it for several weeks, you must
charge the battery pack completely.
The L 50 charger (see “ Accessories” on page 30) can charge two
BA 5000-2 battery packs simultaneously.
After you have changed the power pack, the radio microphone
continues operating on exactly the same settings as before the
change. Stored settings are retained in memory on switch-off.
̈ To open the battery box, push down the
display section ¸ of the battery box ».
̈ Insert the batteries. Observe correct
polarity when inserting the batteries.
̈ Close the battery box.
• 3-step LC display for remaining battery
capacity.
• If the battery capacity is too low (LOW
BATT), the last segment starts flashing
and the batteries must be changed.
¸
¸
LOW BATT