Filter
Top Products
15
Connecting the amplifier/mixing console
The EM 100 G2’s audio outputs are available as an XLR-3M socket ᕨ and a
¼” (6.3 mm) jack socket ᕩ, allowing you to simultaneously connect two
units (e.g. amplifier, mixing console). The adjusted audio output level is com-
mon for both sockets.
̈ Connect the amplifier/mixing console to the XLR-3M socket ᕨ or the
¼” (6.3 mm) jack socket ᕩ.
For detailed information on balanced and unbalanced connection, please
refer to the section “Connector assignment” auf Seite 43.
̈ Via the operating menu, adapt the level of the audio output (AF OUT) to
the input of the amplifier or mixing console (see: „Adjusting the audio
output level (receivers only)“ on page 33).
Service interface
The service interface µ is only required for servicing purposes.
19” rack adapter and antenna mount (accessories)
For mounting one or two receivers into a 19” rack, you require the GA 2 rack
adapter. The GA 2 rack adapter consists of:
y 2 rack mount “ears” ƺ
y 1 connecting bar ƻ
y 1 connecting plate Ƽ
y 2 covering plugs ƽ for antenna holes
y 12 recessed head screws M 3x6
y 2 recessed head screws M 6x10
When mounting only one receiver into a rack, you can use the AM 2 antenna
mount (available as an accessory) to mount the transmitter’s antenna con-
nection to the front of the GA 2 rack adapter. The AM 2 antenna mount con-
sists of :
y 2 BNC extension cables (screw-in BNC socket ƾ to BNC connector ƿ)
y 2 plains washers
y 2 nuts
º ¾
µ
ƻ
Ƽ
ƽ
ƺ
ƿ
ƾ