Filter
Top Products
16
To mount two EM 100 G2 into a rack:
̈ Place the two receivers side by side onto a flat sur-
face, their bottom sides facing upwards.
̈ Align the connecting plate Ƽ over the holes in the
bottom sides of the receivers.
̈ Secure the connecting plate Ƽ to the receivers
using eight of the supplied recessed head screws
(M 3x6).
̈ Hook the two rack mount “ears” ƺ to the front
panels of the receivers.
̈ Secure the rack mount “ears” to the receivers using
two of the supplied recessed head screws (M 3x6)
respectively.
̈ Slide the receivers into a 19” rack.
̈ Screw the rack mount “ears” tight.
When mounting only one receiver into a rack, use the
connecting bar ƻ instead of the second receiver.
̈ Hook the two rack mount “ears” ƺ to the front
panel of the receiver.
̈ Secure the rack mount “ears” to the receiver using
two of the supplied recessed head screws (M 3x6)
respectively.
̈ Secure the connecting bar ƻ to one of the rack
mount “ears” ƺ using two of the supplied recessed
head screws (M 6x10).
̈ If you are not front mounting the antennas, insert
the two covering plugs ƽ into the antenna holes of
the connecting bar.
̈ Slide the receiver into a 19” rack.
̈ Screw the rack mount “ears” tight.
To mount the receiver’s antenna connection to the
front of the GA 2 rack adapter using the AM 2 antenna
mount:
̈ Screw the two BNC sockets ƾ of the BNC extension
cables to the connecting bar ƻ using the supplied
plain washers and nuts.
̈ Connect the two BNC connectors ƿ to the BNC
sockets ¸ and Ƹ at the rear of the receiver.
̈ Slide the receiver into a 19” rack.
̈ Screw the rack mount “ears” tight.
̈ Connect the two telescopic antennas ƹ to the two
BNC sockets ƾ.
̈ Pull the telescopic antennas out and align them
upwards in a V-shape.
ƺ
ƺ
Ƽ
ƻ
ƺ
ƺ
ƽ
ƿ ƾ
ƻ
ƹ