Filter
Top Products
18
Mounting the bodypack receiver to a camera
Use the supplied camera kit to mount the receiver to the camera’s flash
mount.
The camera kit consits of:
y 1 perforated plate ¹
y 1 flash mount adapter Ƹ
y 2 square nuts ƹ
̈ Determine where on the perforated plate the flash mount adapter Ƹ will
need to be fastened so that the receiver can best be attached to the
camera.
̈ At this position, place a square nut ƹ under the perforated plate ¹.
̈ Fasten the flash mount adapter to the perforated plate using the square
nut.
̈ Remove the belt clip.
̈ Place the perforated plate ¹ onto the rear of the receiver.
̈ Reinsert the belt clip.
SK 100 G2 bodypack transmitter
Inserting and replacing the batteries
For powering the SK 100 G2 bodypack transmitter, you can either use two
1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack.
̈ Press the two unlocking buttons ᕩ and open the battery compartment
cover ᕨ.
̈ Insert the two batteries or the BA 2015 accupack as shown in the diagram
on the left. Please observe correct polarity when inserting the batteries/
accupack.
̈ Close the battery compartment. The battery compartment cover ᕨ locks
into place with an audible click.
Note:
For important informations on charging the accupack see: „Inserting and
replacing the batteries“ on page 17.
Connecting the microphone/line cable
The microphone/line input is designed for the connection of both condenser
microphones and instruments (e.g. guitars). DC powering of the condenser
microphones is via the microphone/line input.
̈ Connect the 3.5 mm jack plug Ƹ from the microphone/line cable to the
3.5 mm jack socket (MIC/LINE) ᕡ.
̈ Lock the 3.5 mm jack plug by screwing down the coupling ring ƹ.
̈ Via the operating menu, adjust the sensitivity of the microphone/line
input (MIC/LINE) (see: „Adjusting the sensitivity (transmitters only)“ on
page 32).
¹
Ƹ
ƹ
¾
º
º
³
ƹƸ