Filter
Top Products
22
Using the components
Switching the components on/off
The ew 100 G2 transmitters and receivers can only be switched off when the
standard display is shown on the display panel. Within the operating menu,
the ON/OFF button or the POWER button (EM 100 G2 only) serves as the ESC
(cancel) key, i.e you cancel your entry and return to the standard display.
Note:
Remove the batteries or the accupack when the units will not be used for
extended periods of time.
Switching the rack-mount receiver on/off
̈ Press the POWER button ´ to switch the receiver on.
̈ To switch the receiver off, press the POWER button until “OFF” appears on
the display.
Switching the bodypack receiver/transmitter on/off
̈ Press the two unlocking buttons ᕩ and open the battery compartment
cover ᕨ.
̈ Press the ON/OFF button µ to switch the bodypack receiver/transmitter
on. The red LED » lights up.
̈ To switch the bodypack receiver/transmitter off, press the ON/OFF button
µ until “OFF” appears on the display. The red LED » goes off.
̈ Close the battery compartment. The battery compartment cover ᕨ locks
into place with an audible click.
Switching the plug-on transmitter on/off
̈ Press the ON/OFF button ᕨ to switch the plug-on transmitter on. The red
LED ᕧ lights up.
̈ To switch the plug-on transmitter off, press the ON/OFF button ᕨ until
“OFF” appears on the display. The red LED ᕧ goes off.
´
¾
º
µ
»
¶
º