Filter
Top Products
34
Power Supply
Power Supply
This section explains the power supply for
each component.
Diversity tuner module (URX-
M2)
When incorporated into another component
(e.g., MB-X6, SRP-X500P, etc.), the tuner
module draws its power from that
component.
For details on the power supply to the diversity tuner
module, refer to the operating instructions of the
component in which the diversity tuner module is
installed.
Body-pack transmitter (UTX-
B2), hand-held microphone
(UTX-H2), plug-on transmitter
(UTX-P1), and portable
diversity tuner (URX-P2)
These components can be powered by two
LR6 (size AA) alkaline batteries. Details on
inserting the batteries and the battery
condition indication are given below:
The manganese batteries cannot draw
sufficient performance from the
component. Be sure to use the alkaline
batteries.
Inserting the batteries
Body-pack transmitter (UTX-
B2)/portable diversity tuner
(URX-P2)
The procedure below uses the body-pack
transmitter (UTX-B2) in the illustrations.
Batteries can also be inserted in the portable
diversity tuner (URX-P2) in the same
manner.
1 Slide the battery-compartment catches
inward (in the direction of the arrows b
B) to take out the battery holder.
2 Match the polarities and insert the
batteries, then set the battery
compartment in the original position.
Taking out the battery compartment during
signal transmission may cause high noise.
Be sure to turn off the component before
taking out the battery compartment.
Hand-held microphone (UTX-
H2)
1 Turn the grip in the direction of the
arrow to open the battery
compartment.
Note
Note