Filter
Top Products
41
Operation
To install a diversity tuner
module (URX-M2) into the
SRP-X500P Powered Mixer
The SRP-X500P Powered Mixer can
accommodate up to two diversity tuner
modules (URX-M2).
For details on installation procedure, refer to the
Operating Instructions supplied with the SRP-
X500P.
Remove the protection panel (large) from
the SRP-X500P. Inspect the top and bottom
sides of the diversity tuner module and
insert it into the slot.
To uninstall the tuner module
Pull the latch securing the tuner module to
the side and pull out the tuner module.
Operation
The procedure below is the same
for all UWP series transmitters
(UTX-B2/H2/P1) and tuners (URX-
P2/M2).
1 Make all necessary connections on the
tuner.
For examples of UWP series component
connections, see “System Configurations” on
page 49.
2 Turn on the tuner.
The parameters that were in the display
section when the tuner was last turned
off appear again.
Noise will be produced when the tuner
is turned on. Before turning on the
tuner, turn down the volume of the
equipment connected to the tuner.
3 Set the reception channel on the tuner.
Switch the channel on the tuner with
the transmitter turned off and select the
channel where the RF indicator does
not turn on.
For details on setting the reception channel,
see “Setting the reception channel” on
page 42.
4 Set the transmission channel on the
transmitter, and then turn off the unit.
For details on setting the transmission
channel, see “Setting the transmission
channel” on page 46.
5 Turn on the transmitter.
Latch
Note