Filter
Top Products
43
Tuner Settings
Hold down the + or – button to change
the channel group faster.
4 When the desired channel group
number appears, press the SET button.
The selected group is entered.
The right four digits start to flash to
allow the selection of the channel
number.
5 Press the + or – button to select the
channel number.
The channel indication changes in the
order shown in the tables in the pdf
files “Sony Wireless Microphone
System Frequency List” on the
supplied CD-ROM (for U30, U42,
CE62, and CE67 models).
6 When the desired channel number
appears, leave the tuner for about 10
seconds or press down the SET button
for more than one second.
The selected channel number stops
flashing and the selection is stored in
memory.
To select the channel by
frequency indication
1 Press the SET button for more than one
second.
Keep pressing the SET button until the
display section parameters start to
flash.
2 Press the SET button repeatedly until
the frequency indication appears and
starts flashing.
3 Press the + or – button to select the
frequency.
4 When the desired frequency appears,
leave the tuner for about 10 seconds or
press down the SET button for more
than one second.
The selected channel number stops
flashing and the selection is stored in
memory.
• Even when you are setting the reception
channel, the tuner can be used to receive
signals.
• Do not remove the batteries while setting
the reception channel. If they are
inadvertently removed, re-insert them
immediately and redo the procedure
“Setting the reception channel” from
step 1.
• Make sure that the selected channel is the
same on the transmitter and tuner being
used in the same system.
• If you turn off the tuner and then
immediately turn it on right after setting
the reception channel, the unit may not
Example: When the channel group 00 is
selected
Notes