Filter
Top Products
36
Attachment and Installation Procedures
The indicated battery condition may not be
correct if the batteries were not new when
installed. If you plan to use the component
for a long period, it is recommended that
you replace the batteries with brand new
ones.
Notes on battery
Batteries may leak or explode if mistreated.
Be sure to follow these instructions.
• Be sure to install the batteries with the
correct polarity.
• Always replace the two batteries
together.
• Do not use different types of batteries or
old and new one together.
• The batteries are not rechargeable.
• When not using the component for a long
period of time, remove the batteries to
avoid leakage. If the batteries do leak,
clean all leakage from the battery
compartment and the component.
Leakage left in the compartment and the
component may cause poor battery
contact. If there seems to be poor battery
contact, consult your Sony dealer.
Attachment and
Installation
Procedures
This section describes the procedures for
attaching the supplied accessories to the
components and the installation of the
diversity tuner module (URX-M2) into the
MB-X6 Tuner Base Unit or SRP-X500P
Powered Mixer.
Attaching the supplied
accessories to the body-
pack transmitter (UTX-B2)
To attach the microphone
Be sure to attach or remove the microphone
after turning off the transmitter.
3Lights
Less than 20%
charged
4 Flashes Almost drained
Note
BATT
indication
Battery status
Note
Microphone (supplied)
For a secure connection, be sure to turn
and lock the connector cover.