Filter
Top Products
Receiver Set-up
Connect the supplied AC power adapter to an AC outlet supplying
105 to 125 volts AC, 60 Hz. The 230 volt export model should
connect to an AC outlet supplying 210-240 VAC, 50-60 Hz.
Connect the USR-100 to your equipment:
Insert a 3 pin female “XLR” audio connector and cable into the
Audio Output receptacle on the rear of the USR-100.
Insert the other end of the audio cable into the input of your
Mixer/Amplifier.
Set the Audio Level Switch on the USR-100 to match the input
level of your audio system.
If utilizing the two 1/4 wave antennas supplied, connect both of them
to the back of the receiver at a 90 angle as shown in Figure 3. Tighten
the connectors securely. (If using other types of antennas, refer to the
placement instructions on page 14 of this manual.)
Figure 3
Antenna Mounting
-9-