Filter
Top Products
24
The Function Mode
F4.2: Split Balance.....................................................................................................................................
The volume levels of the two voices combined in the split mode can be adjusted as re-
quired by using this function. Use the [–/NO] and [+/YES] buttons to adjust the balance as
required. The balance range is from 0 through 20. A setting of “10” produces equal balance
between the two split-mode voices. Settings below “10” increase the volume of the left-hand
voice in relation to the right-hand voice, and settings above “10” increase the volume of the
right-hand voice in relation to the left-hand voice. Press the [–/NO] and [+/YES] buttons
simultaneously to recall the default setting (different for each voice combination).
F4.3: Right Voice Octave Shift......................................................................................................
F4.4: Left Voice Octave Shift ..........................................................................................................
Depending on which voices you combine using the split mode, the combination may sound
better if one of the voices is shifted up or down an octave. Use the [–/NO] and [+/YES]
buttons to set the octave of the left-hand or right-hand voice as required. The available settings
are “0” for normal pitch, “–1” to shift the pitch down one octave, and “1” to shift the pitch up
one octave. Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting
(different for each voice combination).
F4.5: Right Voice Effect Depth......................................................................................................
F4.6: Left Voice Effect Depth..........................................................................................................
These functions make it possible to individually set the depth of the chorus effect for the
left-hand and right-hand split-mode voices. Use the [–/NO] and [+/YES] buttons to set the
effect depth for the corresponding voice as required. The depth range is from 0 through 20. A
setting of “0” produces no effect, while a setting of “20” produces maximum effect depth.
Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting (the default
effect depth setting is different for each voice).
NOTE
• The effect depth settings cannot be changed unless the EFFECT is ON. The Function mode must be
exited before EFFECT can be turned ON.
F4.7: Damper Mode...................................................................................................................................
The Damper Mode function determines whether the damper pedal affects the right voice,
the left voice, or both the left and right voices in the split mode. Use the [–/NO] and [+/YES]
buttons to select “2” for the left voice, “1” for the right voice, or “ALL” for both voices. Press
the [–/NO] and [+/YES] buttons simultaneously to recall the default setting: “ALL”.
F4.8: Reset .........................................................................................................................................................
This function resets all split-mode functions to their default values. Press the [+/YES]
button to reset the values. “End” will appear on the display when all functions have been
reset.