Filter
Top Products
25
The Function Mode
F5
CLP-511 Metronome Functions
After selecting “F4.Y” or “F5.Y”, press the [+/YES] button to engage the metronome
function sub-mode, then use the [<] and [>] buttons to select the desired metronome func-
tion, as listed below.
■ SHORTCUT: You can jump directly to the metronome functions by pressing the [FUNC-
TION] button while holding the [METRONOME] button.
F4.1/F5.1: Beat ...............................................................................................................................................
Use this function to set the time signature of the metronome as required (i.e. the number of
unaccented beats that occur between each accented beat). Use the [–/NO] and [+/YES]
buttons to set the time signature to “0” (no accent), or a value between “2” and “6”, as re-
quired. Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting: “0”.
F4.2/F5.2: Volume .......................................................................................................................................
Use the [–/NO] and [+/YES] buttons to set the metronome volume as required. The vol-
ume range is from 1 through 20. A setting of “1” produces minimum sound, while a setting of
“20” produces maximum metronome volume. Press the [–/NO] and [+/YES] buttons simulta-
neously to recall the default setting: “10”.
F4
CLP-411 Metronome Functions
F6
CLP-511 Left Pedal Mode
This function sets the left pedal for normal soft-pedal operation, or for song start/stop
operation. Use the [–/NO] and [+/YES] buttons to select the desired left-pedal mode. “1” is
the normal soft-pedal mode, and “2” is the start/stop mode. When the start/stop mode is
selected, the left-pedal functions in the same way as the panel [START/STOP] button.
F5
CLP-411 Left Pedal Mode
F7
(CLP-511) Piano Song Part Cancel Volume
This functions sets the volume at which a “canceled” part is played during piano song
playback on the CLP-511 (see page 9 for information on the “part-cancel” function). Use the
[–/NO] and [+/YES] buttons to set the volume as required. The volume range is from 0
through 20. A setting of “0” produces no sound, while a setting of “20” produces maximum
volume. Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting:
“5”.