Filter
Top Products
Using a Microphone — MIC.
129
CVP-900
Vocal Harmony Parameter List
Chordal Type/Vocoder Type Determines how the harmony notes are applied.
Harmony Gender Type Can be set to “Off” or “Auto”. When “Auto”, the gender of the harmony sound is changed automatically.
Lead Gender Type Determines whether and how the gender of the lead vocal sound (i.e., the direct microphone sound) will be
changed. When “Off” no gender change occurs. When “Unison”, “Male” or “Female” is selected the
corresponding gender change is applied to the lead vocal. (In this case the number of harmony notes which
can be produced in addition to the lead vocal is reduced to one.)
Lead Gender Depth Adjusts the degree of lead vocal gender change produced when one of the Lead Gender Types (above) is
selected.
Lead Pitch Correction When “Correct” is selected the pitch of the lead vocal is shifted in precise semitone steps. This parameter is
only effective when one of the Lead Gender Types is selected.
Auto Upper Gender Threshold Gender change will occur when the harmony pitch reaches or exceeds the specified number of semitones
above the lead vocal pitch.
Auto Lower Gender Threshold Gender change will occur when the harmony pitch reaches or exceeds the specified number of semitones
below the lead vocal pitch.
Upper Gender Depth Adjusts the degree of gender change applied to harmony notes higher than the Auto Upper Gender
Threshold.
Lower Gender Depth Adjusts the degree of gender change applied to harmony notes lower than the Auto Lower Gender
Threshold.
Vibrato Depth Sets the depth of vibrato applied to the harmony sound. Also affects the lead vocal sound if a Lead Gender
Type is selected.
Vibrato Rate Sets the speed of the vibrato effect.
Vibrato Delay Specifies the length of the delay before the vibrato effect begins when a note is produced.
Harmony 1/2/3 Volume Sets the volume of the first, second, or third harmony note, respectively. Harmony notes 1 - 3 are assigned in
order of ascending pitch (1 is the lowest pitch, 3 is the highest).
Harmony 1/2/3 Pan
Specifies the stereo (pan) position of the first, second, or third harmony note, respectively. Harmony notes 1 - 3
are assigned in order of ascending pitch (1 is the lowest pitch, 3 is the highest). When “Random” is selected the
stereo position of the sound will change randomly whenever the keyboard is played.
Harmony 1/2/3 Detune Detunes the first, second, or third harmony note respectively by the specified number of cents. Harmony
notes 1 - 3 are assigned in order of ascending pitch (1 is the lowest pitch, 3 is the highest).
Pitch to Note When “ON” the lead vocal sound “plays” the CVP-900 tone generator system. (However, dynamic changes in
the vocal sound do not affect the volume of the tone generator.)
Pitch to Note Part Determines which of the CVP-900 parts will be controlled by the lead vocal when the Pitch to Note
parameter is “ON”.
1
2
3
4
5
6
7
8
A
B
C
D
E
F
G
H
I
J
Save the changed data
(page 39, 45).
The saved settings can be
named (page 42) or deleted
(page 44) in the USER
page.
3
Press the [EXIT] button to return to the previous
display.
Select a Vocal Harmony type.
Select a Vocal Harmony parameter (see below).
Adjust the parameter value.
Return to the VOCAL HARMONY TYPE
display.
END