Filter
Top Products
161
CVP-900
Keyboard Stand Assembly
CAUTION
■ Be careful not to confuse parts, and be sure to install all parts
in the correct orientation. Please assemble in accordance
with the sequence given below.
■ Assembly should be carried out by at least two persons.
■ Be sure to use the correct screw size, as indicated below. Use
of incorrect screws can damage the stand.
■ Be sure to tighten all screws upon completing the assembly
of each unit.
■ To disassemble, reverse the assembly sequence given below.
1
Remove all parts from the box. Confirm that all
parts shown in the illustration are included.
Main unit
How to position the main unit
Spread a large soft cloth, such as a blanket, on the
floor. Place the unit on the cloth with the key cover
closed and the keyboard side on the bottom and
lean the unit against the wall so that the unit will not
fall or slip. Place a soft cloth against the wall to
protect the instrument and the wall from scratches.
2
Attach two front legs and a rear leg.
Refer to the diagram below to verify the orientation
of the legs.
Install and tighten four screws on each leg, starting
with one of the front legs.
3
Install the pedal box.
1 Remove the plastic tie that affixes the pedal cord
to the upper portion of the pedal box.
2 Align the cord with the groove on the unit, and
attach the pedal box using four screws.
Have a Phillips-head (+) screwdriver ready.
Lean the unit against the
wall as shown below.
Legs Pedal box
AC power cord 6×25 mm fixing screws ×16
Cord holder
CAUTION
Be careful not to pinch your fingers.
Be sure to position the keyboard side on the bottom.
CAUTION
Do not place the main unit with the rear
side facing down.
CAUTION
Do not lay the main unit upside down
on the floor.
CAUTION
Do not position the main unit so that
its bottom is in contact with floor.
Rear leg
Front leg Front leg
Plastic tie