Filter
Top Products
29
1-5. Hi-Hat Offset
This sets the value of the data sent by a foot controller connected
to the HI HAT CONTROL jack on the rear panel. Set a + (plus) or
– (minus) level.
UT SYSTEM
HH OffS= 0T= 32
q HH OFFS (Hi-Hat Offset)
When a low data value is received from the foot controller, the
voice will sound sooner. So, slightly pressing the foot controller
will result in the voice sounding. In the case of the hi-hat control-
ler, delicate adjustment of the controller’s “closed” point is pos-
sible.
w T (Foot Splash Detect Time)
Sets the detect time for the foot splash. Large values make foot
splashes easier to produce.
*Values too large will result in splashes being produced under
normal hi-hat use.
q w
1-6. Factory Set
This function replaces all internal settings in the DTXPRESS to
their factory-set condition.
UT SYSTEM
Factory Set
The Factory Set function will replace all internal set-
tings in the DTXPRESS to their factory-set condi-
tion. Take care so as not to loose important data.
Make sure any settings and user songs you want to
keep have been saved to an external device such as
the Yamaha MIDI Data Filer MDF3, etc. (m[2-1.
Bulk Dump] (P. 29)
Procedure
1.
Enter the display shown above, press the [SAVE/ENT]
button. The following display will appear asking for con-
firmation before the Factory Set operation is carried out.
2.
Once again, press the [SAVE/ENT] button to proceed
with the operation.
All data will be
lost.AreYouSure?
2. MIDI Group
This sub-mode contains functions and settings for the MIDI and
TO HOST jacks of the DTXPRESS. This group is divided into the
following 10 pages.
2-1. Bulk Dump....................................................... 29
2-2. Channel 10 Program Change/
Channel Event Receive ................................... 30
2-3. Receive Program Change/
System Exclusive Messages ........................... 30
2-4. Program Change Table.................................... 31
2-5. MIDI Mode....................................................... 31
2-6. Device Number, Local Control......................... 31
2-7. MIDI Merge...................................................... 31
2-8. Dump Interval .................................................. 32
2-9. Send Hi-Hat Control ........................................ 32
2-10. Host Thru Port ................................................. 32
* Please refer to the [MIDI Data Format] (P. 50) section for more
information related to MIDI.
2-1. Bulk Dump
With the Bulk Dump operation, data stored in the ETXPRESS can
be transmitted via the MIDI OUT or TO HOST jack.
Utility Mode
q Fmt (Bulk Dump Format)
Selects the type of data to be transmitted with the Bulk Dump
operation.
all data : All the data in the DTXPRESS
system data : Data set in the Utility mode (except User
Map).
user map : User Map data.
one drumkit : Data for the currently selected Drum Kit.
all drumkit : All User Drum Kit Data.
one trigger : Data for the currently selected Trigger Setup.
all trigger : All User Trigger Setup data
one song : Data for the currently selected User Song.
all song : All User Song data.
Procedure
1.
After reading the [Connecting a MIDI Device] (Basic
Guide : P. 12) or the [Connecting a Computer] (Basic
Guide : P. 26) section, connect the external MIDI device
or computer to the MIDI OUT or TO HOST jack on the
DTXPRESS. Set the HOST SELECT switch.
UT MIDI BULKDUMP
Fmt= all data
q