Filter
Top Products
24
English
Mode Functions
This section explains how to route mLAN audio input signals from connected devices to the
mLAN8P and how to set the Mixer function parameters.
Assign any of eight channel signals from the connected devices to channels [1] - [8], Digital In sig-
nals to channels [9] and [10], and A/D In signals to channels [11] and [12].
Use [UTILITY] mode to select Optical or Coaxial for the Digital In connection (P.33).
1. Press the [Mixer 1] or [Mixer 2] button, depending on the target channel.
2. Press the channel button that corresponds to the channel number you wish to set. You can
select channels [1] - [8] for [Mixer 1] and channels [9] - [12] for [Mixer 2].
3. Use the [ PAGE ] button to select a parameter you wish to set. (Move the cursor “ ”
to the parameter.)
Repeatedly pressing the channel button for the currently-selected channel
will switch pages (except for the [Input Device/Nickname] and [Audio In Plug]
parameters.)
4. Use the [+1/ENTER] and [–1/EXIT] buttons or the [VALUE] dial to select the names of the
devices and parameter values.
[Input Device/Nickname]
Use the [Device/Nickname] parameter to specify the name of the device on the mLAN you
wish to connect to the channel selected via the channel button. If you are not connecting any
devices, select “Unconnected.”
A5000 (Nickname=Liverpool) is connected.
No device is connected.
The screen is different for [Mixer 2] channels [9] - [12] (Digital In, A/D In).
Display for A/D Input L ([Mixer 2] channel [11])
Settings for the Mixer Input Section: [Mixer 1/2]
[1] - [12]
NOTE
NOTE