Filter
Top Products
36
English
Mode Functions
D
[MIDI/UTILITY] - [METER]
Follow the steps below to display the level meters. The “C” mark appears when the signal clips.
1. Press the [MIDI/UTILITY] button.
2. Press the [METER] button.
3. Use the [ PAGE ] button to select the level meter group you wish to view (All Ch,
Input, Output, MIDI).
4. Use the [+1/ENTER] and [–1/EXIT] buttons or the [VALUE] dial to select the channel to view.
“All Ch” (All Channels) is selected:
You can view all channels simultaneously to see if any signal is input to the Mixer Input section.
You can also check the outputs from the Mixer section. The LCD displays Ch1-8 (Input 1-8), Op/
Co (Digital In), Ad (A/D In), and Mix/AUX (from left to right). To switch between Mix (Stereo Mix
output) and AUX, use the [+1/ENTER] and [–1/EXIT] buttons or the [VALUE] dial.
“Input” is selected:
e.g., Ch1 and Ch2
"Output” is selected:
e.g., AUX1/2
“MIDI” is selected:
An asterisk (“*”) flashes during MIDI signal transmission and reception.
If the mLAN8P receives MIDI signals at the MIDI IN terminal on the rear
panel, but does not output mLAN MIDI or audio signals to another mLAN
device, an asterisk (“*”) will not appear. On the other hand, if the mLAN8P is
a word clock master, an asterisk flashes when the unit receives MIDI signals,
regardless of whether it is outputting mLAN MIDI/audio signals.
NOTE