Filter
Top Products
PF-500 89
Message List
Message Meaning
1. This message will be displayed if current memory fills up during
recording. Recording will stop automatically at this point. The
data that had been recorded up to that point will remain. This
message will also be displayed when you attempt to enter Record
mode for additional recording if that song already occupies all of
current memory. In this case, additional recording will not be pos-
sible. If there is an already-recorded track that you do not need to
keep, you can use “ChannelClear” (page 66) to delete the
unneeded track, so that you will then be able to record the equiva-
lent amount of additional material.
2. This message will be displayed when you select a song if that song
is larger than the capacity of the current memory (page 90). This
song cannot be loaded into the PF-500, and cannot be played back.
Please select a different song.
This message will be displayed when you edit a song if that song is
larger than the capacity of the current memory (page 90). This song
cannot be edited on the PF-500.
This message prompts you to start the operation. To start, press the
B [+ (YES)] button. Press the [EXIT] button to cancel the operation.
This message prompts you to confirm the execution. Press the
B
[+ (YES)] button to continue. Press the B [– (NO)] button to can-
cel.
This message means that the PF-500 was unable to transmit voice
bulk data. If this message appears, make sure that the power of your
computer is not turned off, that the cable is connected correctly, that
the HOST SELECT switch is set correctly, and that the driver on
your computer is functioning correctly. Then try transmitting the
data once again.
You used a period or space at the beginning of a song name or you
tried to change a song name that includes a character (or characters)
not supported by the PF-500, and the PF-500 could not process the
name. The PF-500 displays the previous screen in three seconds.
Rename the song correctly.