Filter
Top Products
PM1D V2 System Software Installation Guide
10
18 Select [Start online user registration], then click
[Finish].
The browser starts and the user registration page opens.
User registration entitles you to additional information and
support.
19 Turn off the power to the PW1D, then turn it on.
The CS1D starts in normal mode.
The installation is now complete.
Indirect installation
If you access the Internet from another computer (#2), not from
the computer (#1) connected to the CS1D, follow the steps
below to install the software.
Follow Steps 1 through 11 (on page 8) using computer #1, then
proceed with the following.
12 Select [Save registration code to get access key
later.], then click [Next].
The following window opens.
13 Click [Save in file] to save the PRODUCT ID and
registration code as a text file.
You can also write down the ID and code on a piece of
paper.
14 Copy the text file to the computer (#2) that has
access to the Internet.
Follow the steps below on computer #2.
15 Insert the included CD-ROM into the CD-ROM
drive on computer #2, locate the Upgrade folder
on the CD-ROM, then copy the folder onto the
hard disk.
16 Double-click “PM1DUpgrade.exe” in the Upgrade
folder.
The installer window opens.
17 Select [Authorize], [Get access key from
authentication server], then [Have already created
registration code], then click [Next].
The following window opens.
18 Click [Read from file] to read the text file saved in
Step 13.
If you wrote down the ID and code on a piece of paper,
enter the ID and code from the keyboard.
19 Make sure that the correct PRODUCT ID and
registration code are displayed, then click [Next].
The window indicates “To get access key, get ready to
connect to the Internet and click [Next].”
20 Make sure that you are prepared to access the
Internet, then click [Next].
The computer connects to the authentication server and
obtains the access key.
21 When the access key is obtained, the following
window opens:
22 Select [Save access key to write into console
later.], then click [Next].
The following window opens.
The installation procedure will initialize data in the user
memories in the CS1D. Be sure to back up important data
using memoroy card. (Refer to the CS1D Owner’s Manual.)
NOTE: If an error message appears, refer to the Error Message list on
page 13.