Filter
Top Products
Editing VL Voice Part Parameters
22
PrsCtrlDpt (Pressure Control Depth) ...................................................... Settings: -64 … +63
Sets the amount of variation produced by the controller assigned to pressure. The higher the value
the greater the variation. Positive values cause an increase in pressure in response to higher con-
troller values (e.g. increased breath pressure or higher modulation wheel position), while minus
values cause a decrease in pressure in response to higher controller values.
3 Embouchure
Emb CC No. (Embouchure Control Change Number) ...... Settings: off … 95, AT, VEL, PB
“Embouchure” corresponds to the tightness of the lips against the reed or against each other. In a
string instrument voice embouchure corresponds to how strongly the bow is pressed against the
string. Affects both pitch and timbre. The “Emb CC No.” parameter specifies the controller to be
used for embouchure control. When set to “off” medium embouchure is applied at all times.
• Please note that with many voices accurate keyboard/controller pitch is produced only at medium embou-
chure.
EmbCtrlDpt (Embouchure Control Depth) .............................................Setting: -64 … +63
Sets the amount of variation produced by the controller assigned to embouchure. The higher the
value the greater the variation. Positive values cause an increase in embouchure in response to
higher controller values (e.g. increased breath pressure or higher modulation wheel position),
while minus values cause an decrease in embouchure in response to higher controller values.
4 Tonguing
Tng CC No. (Tonguing Control Change Number) ............. Settings: off … 95, AT, VEL, PB
“Tonguing” simulates the half-tonguing technique used by saxophone players by changing the
“slit” of the reed. The slit is the space between the tip of the reed and the mouthpiece. The “Tng
CC No.” parameter specifies the controller to be used for tonguing control. When set to “off” no
tonguing is applied.