Filter
Top Products
27
Editing VL Voice Part Parameters
DmpCtrlDpt (Damping Control Depth) .................................................. Settings: -64 … +63
Sets the amount of variation produced by the controller assigned to damping. The higher the
value the greater the variation. Positive values cause a decrease in damping in response to higher
controller values (e.g. increased breath pressure or higher modulation wheel position), while
minus values cause an increase in damping in response to higher controller values.
11 Absorption
Abs CC No. (Absorption Control Change Number) .......... Settings: off … 95, AT, VEL, PB
“Absorption” simulates the effect of high-frequency loss at the end of the air column or string.
The “Abs CC No.” parameter specifies the controller to be used for absorption control. When set
to “off” no absorption variation can be applied via a controller.
• Please note that accurate keyboard pitch is produced only at when absorption is maximum.
AbsCtrlDpt (Absorption Control Depth) ................................................ Settings: -64 … +63
Sets the amount of variation produced by the controller assigned to absorption. The higher the
value the greater the variation. Positive values cause a decrease in absorption in response to
higher controller values (e.g. increased breath pressure or higher modulation wheel position),
while minus values cause an increase in absorption in response to higher controller values.