Filter
Top Products
30
YDP-101
The Function Mode
F7.5: Control Change ON/OFF ......................................................................................................
Normally the YDP-101 will respond to MIDI control change data received from an external
MIDI device or keyboard, causing the voice on the corresponding channel to be affected by
pedal and other “control” settings received from the controlling device (the keyboard voice is
not affected). The YDP-101 also transmits MIDI control change information when one of its
pedals or other appropriate controls are operated.
This function makes it possible to cancel control change data reception and transmission so
that, for example, the YDP-101 pedals and other controls can be operated without affecting an
external MIDI device.
Use the [–/NO] and [+/YES] buttons to turn control change transmission and reception
“On” or “OFF”.
Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting “On”.
NOTE
• For information on control changes that can be used with the YDP-101, refer to the MIDI Data Format
on page 35.
F7.6: MIDI Transmit Transpose......................................................................................................
This function allows the MIDI note data transmitted by the YDP-101 to be transposed up
or down in semitone steps by up to plus or minus 12 semitones. The pitch of the YDP-101
itself is not affected.
Use the [–/NO] and [+/YES] buttons to set the desired amount of MIDI transmit transposi-
tion. The range is from “–12” (down one octave) through “0” (no transposition) to “12” (up
one octave).
Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting “0”.
F7.7: Panel/Status Transmit .............................................................................................................
This function causes all the current YDP-101 panel settings (selected voice, etc.) to be
transmitted via the MIDI OUT terminal. This is particularly useful if you will be recording
performances to a MIDI sequence recorder which will be used to control the YDP-101 on
playback. By transmitting the YDP-101 panel settings and recording them on the MIDI
sequence recorder prior to the actual performance data, the YDP-101 will be automatically
restored to the same settings when the performance is played back.
Press the [+/YES] button to transmit the panel/status data. “End” will appear on the LED
display when the data has been successfully transmitted.
NOTE
• See page 36 for list of the “Panel Data Contents” transmitted by this function.
• Panel setting data that is transmitted to an external device can only be reloaded on a model of the
same type. Panel setting data can also be directly transferred to or from instruments of the same
model type.
F7.8: Bulk Data Dump ............................................................................................................................
This function is used to transmit all data stored in the Recorder memory to a MIDI data
storage device, other sequence recorders or MIDI compatible computers.
Press the [+/YES] button to begin bulk transmission. “End” will appear on the LED
display when the data has been successfully transmitted.
NOTE
• Bulk data dump will not function when the recorder is in operation.
• Recorder data that is transmitted to an external device can only be reloaded on a model of the same
type. Recorder data can also be directly transferred to or from instruments of the same model type.
• The reload operation cannot be executed when the Recorder is in operation or the Function mode is
engaged.
•
No MIDI data transmission or data reception occurs during a bulk data dump transmit operation.
28