Filter
Top Products
ZOOM B2
8
Selecting a Patch
A1
HINT
Turn power on
Set the B2 to play mode
Use a shielded cable with mono phone plug
to connect the bass guitar to the [INPUT]
jack of the B2.
When using the B2 with the AC adapter,
plug the adapter into the outlet and plug
the cable from the adapter into the [DC
IN] jack on the B2.
Turn the bass guitar amplifier on and
adjust the volume to a suitable position.
If the Module selector is set to a position
other than "PLAY", set it to "PLAY".
The bank and patch
that were selected
when the power was
last turned off will
appear on the display.
Select a patch
To switch the patch, press one of the [W]/[Q] foot switches.
Pressing the [W] foot switch calls up the next lower patch, and pressing the [Q] foot
switch calls up the next higher patch.
Repeatedly pressing one foot switch cycles through patches in the order A0 – A9 ... d0 – d9
→ 00 – 09 ... 30 – 39 → A0, or the reverse order.
Immediately after turning the B2 on, the
unit will be in play mode, even if the
Module selector is set to a position other
than "PLAY".
Set the [POWER] switch on the rear
panel of the B2 to ON.
Bank name Patch number
To try out the various effects of the B2, we recommend that you simply play your instrument while
switching patches.
EB2.fm 8 ページ ２００５年７月２７日 水曜日 午後４時１５分