Zoom G1XN Music Pedal User Manual


  Open as PDF
of 16
 
8
ZOOM G1N/G1XN
9
ZOOM G1N/G1XN
Selecting a Patch for Playing (Play Mode)
Selecting a Patch for Playing (Play Mode)
Bank
name
Patch
number
MN
MN
The volume control on the connected amplifier
should be turned down.
When using the unit on batteries
Plugashieldedcableintothe[INPUT]jack.
When using the unit with an AC adapter
Plugthecablefromtheadapterintothe[DCIN]
jack.
Turntheguitaramplifieronandadjustthevolumeto
a suitable position.
Set the Module selector to "PLAY".
The bank and patch number are shown on the display.
Immediately after turning the G1N/G1XN on, the unit
will be in play mode, regardless of the position of the
Module selector.
Turn power on
1
Set the G1N/G1XN to play mode
2
Directly switch a bank
4
Adjust the master level
5
Press the [BANK UP·TAP] key.
Repeatedlypressingthekeycyclesthroughbanksin
the order A ... d, 0 ... 3, A.
With the G1N, using the foot switch (FS01) to switch
banks is also possible (
g
p. 18).
Operate the [VALUE] knob.
The master level setting appears on the display.
The master level setting applies to all patches. The
settingrangeis0–98,1.0.Itwillberesetto80when
power is turned off and then on again.
When using headphones, this knob adjusts the listening
volume.
Select a patch
3
Use the foot switches.
Press the [
Q
]footswitchtocallupthenexthigher
patch.
Press the [
W
]footswitchtocallupthenextlower
patch.
Repeatedlypressingonefootswitchcyclesthrough
patchesintheorderA0–A9...d0–d9,00–09...
30–39,A0.
This section explains basic functions of the play mode.
HINT
HINT
HINT
80
A0 B0
A0 A1
A0 39
 previous next