Filter
Top Products
ZOOM RFX-1100
6
1. Verify that the AC cable, sound source, and
playback system are correctly connected to
the RFX-1100.
The INPUT control and OUTPUT control of the
RFX-1100 as well as the volume control of the
playback system should be set to minimum.
2. Turn on the system in the following order:
sound source RFX-1100 playback
system.
3. While playing the
sound source, turn
up the INPUT control
of the RFX-1100 to
adjust the input level.
To minimize noise and distortion, the INPUT control
should be set as high as possible without causing the
CLIP LED to light.
4. Adjust the OUTPUT control and the volume
control of the playback equipment to obtain
a suitable playback volume.
5. Use the BANK selector and the EFFECT
TYPE selector to select the desired effect.
Depending on the position of the BANK selector, the
available effects are as shown below.
CLIP LED
Select bank with BANK selector
Select effect with
EFFECT TYPE selector
Guitar
amplifier
Keyboard
amplifier
Synthesizer
Guitar
RFX-1100
OUTPUT
RR
L/MONO
L
INPUT
Preamplifier or
distortion effect
or similar
Using Two Effects in Parallel
The RFX-1100 allows using two effects at the same time (in parallel). This is possible with effects from the EFFECTS
bank which have a double name separated with a slash ("/"). The following illustration shows a connection example for
using two effects independently in the left and right channel.
Keyboard amplifiers
Microphone
Synthesizer
MD player or sampler or similar
with recorded voice
RFX-1100
OUTPUT
R
R
L/MONO
L
INPUT
MIC IN
This is a connection example for using the VOCODER effect from the MIX&SFX bank. Connect a dynamic microphone
to the front-panel MIC IN jack on the RFX-1100. Connect a synthesizer or other instrument to the rear-panel INPUT
L/MONO jack. You can then use the mic to vary the envelope (volume change curve) and the sound character of the
VOCODER effect. Instead of the mic, it is also possible to use the right- channel signal for controlling the effect. In this
case, the signal supplied to the INPUT L/MONO jack is controlled by the signal supplied to the INPUT R jack. Verify
that the MIC IN indicator is lit. If not, press the MIC ON/OFF switch so that the indicator comes on.
Using the VOCODER Effect
Getting Connected / Trying Out the Effects
Trying Out the Effects