set radio-profile auto-tune power-interval 281
When RF Auto-Tuning for power is enabled, MSS does not allow you to
manually change the power level.
Examples — The following command enables dynamic power tuning for
radios in the rp2 radio profile:
WX4400# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
See Also
■ “set {ap | dap} radio auto-tune max-power” on page 266
■ “set {ap | dap} radio auto-tune max- retransmissions” on page 267
■ “set radio-profile auto-tune channel-config” on page 276
■ “set radio-profile auto-tune power-backoff- timer” on page 279
■ “set radio-profile auto-tune power-interval” on page 281
set radio-profile
auto-tune
power-interval
Sets the interval at which RF Auto-Tuning decides whether to change the
power level on radios in a radio profile. At the end of each interval, MSS
processes the results of the RF scans performed during the previous
interval, and changes radio power levels if needed.
Syntax —
set radio-profile name auto-tune
power-interval seconds
■ name — Radio profile name.
■ seconds — Number of seconds MSS waits before changing radio
power levels to adjust to RF changes, if needed. You can specify from
1 to 65535 seconds.
Defaults — The default power tuning interval is 300 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — RF Auto-Tuning also can temporarily increase a radio’s power
level to preserve the minimum data rate for an associated client. In this
case, the radio reduces its power in 1 dBm increments until the power
returns to the expected level.
