19
TRACE COMMANDS
Use trace commands to perform diagnostic routines. While MSS allows
you to run many types of traces, this chapter describes commands for
those traces you are most likely to use. For a complete listing of the types
of traces MSS allows, type the set trace ? command.
CAUTION: Using the set trace command can have adverse effects on
system performance. 3Com recommends that you use the lowest levels
possible for initial trace commands, and slowly increase the levels to get
the data you need.
Commands by
Usage
This chapter presents trace commands alphabetically. Use Table 93 to
locate commands in this chapter based on their use.
clear log trace Deletes the log messages stored in the trace buffer.
Syntax — clear log trace
Defaults — None.
Table 93 Trace Commands by Usage
Type Command
Trace “set trace sm” on page 486
“set trace dot1x” on page 486
“set trace authentication” on page 484
“set trace authorization” on page 485
“display trace” on page 483
“save trace” on page 484
“clear trace” on page 482
“clear log trace” on page 481
