40 CHAPTER 3: SYSTEM SERVICE COMMANDS
■ location — Resets the location of the WX switch to null.
■ name — Resets the name of the WX switch to the default system
name, which is the model number.
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To clear the location of the WX switch, type the following
command:
WX4400# clear system location
success: change accepted.
See Also
■ “display config” on page 470
■ “display system” on page 42
■ “set system contact” on page 51
■ “set system countrycode” on page 51
■ “set system ip-address” on page 53
■ “set system location” on page 54
display banner
motd
Shows the banner that was configured with the set banner motd
command.
Syntax —
display banner motd
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To show the banner with the message of the day, type the
following command:
WX4400# display banner motd
hello world
