set service-profile auth-dot1x 295
Examples — The following command changes the short retry threshold
for radio profile rp1 to 3:
WX4400# set radio-profile rp1 short-retry 3
success: change accepted.
See Also
■ “display radio-profile” on page 254
■ “set radio-profile mode” on page 287
■ “set radio-profile long-retry” on page 284
set service-profile
auth-dot1x
Disables or reenables 802.1X authentication of Wi-Fi Protected Access
(WPA) clients by MAP radios, when the WPA information element (IE) is
enabled in the service profile that is mapped to the radio profile that the
radios are using.
Syntax —
set service-profile
name auth-dot1x {enable | disable}
■ name — Service profile name.
■ enable — Enables 802.1X authentication of WPA clients.
■ disable — Disables 802.1X authentication of WPA clients.
Defaults — When the WPA IE is enabled, 802.1X authentication of WPA
clients is enabled by default. If the WPA IE is disabled, the auth-dot1x
setting has no effect.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command does not disable dynamic WEP for non-WPA
clients. To disable dynamic WEP for non-WPA clients, enable the WPA IE
(if not already enabled) and disable the 40-bit WEP and 104-bit WEP
cipher suites in the WPA IE, if they are not already disabled.
To use 802.1X authentication for WPA clients, you also must enable the
WPA IE.
If you disable 802.1X authentication of WPA clients, the only method
available for authenticating the clients is preshared key (PSK)
