46
PQ-8P, PQ-8S
COMMAND 89: 16.7 CPI STRING
Used with Generic output protocol
to define the 16.7 CPI string. See
command 84.
VALUE DESCRIPTION
1(up to 25 Defines the 16.7
hex bytes) CPI string
1() Deletes the 16.7
CPI string
Example: &%Z89,1(1B 10) stores
the 16.7 (actually: 17 CPI normal
draft) CPI command for an IBM
Proprinter X24E (hex value 1B 10)
in the PQ-8’s memory.
COMMAND 98: RESTORE
DEFAULTS OR PRINT
CONFIGURATION
Restores the factory-default
configuration selections, prints out
a copy of the active configuration
selections, or restores the permanent
memory selections to the active
setup status.
VALUE DESCRIPTION
0 Restores the factory
setup
1 Prints out the active
setup selections
2 Restores the setup
selections stored in
the permanent
memory to active
status
NOTES
If a document is printed
using temporary host
download commands
(commands not stored using
the Z99,0 command), value 2
will restore the permanent
memory selections.
Put a &%Z98,2 at the end of
the document to restore the
standard setup parameters
for the next user of the
printer.
The active setup and
permanent memory setup
selections are the same after
a Command Z99,0 or a
Command Z98,2 is sent to
the printer.
Example: &%Z98,1 prints out the
active setup selections for review.
COMMAND 99: SAVE ALL
CURRENT SETTINGS
Saves all current settings specified
through Host/PC download
commands or Setup Software into
permanent memory.
VALUE DESCRIPTION
0 Save all current
settings
Example: &%Z99,0 saves all current
settings to permanent memory.
