47
PQ-8P, PQ-8S
4.5 Restoring Factory Defaults
The factory-default configuration
can be restored either by sending
Host/PC Download Command
“Z98,0” or by taking the following
steps:
1. Power off the printer and the
PQ-8.
2.Disconnect the host and PC
sharing cables from the PQ-8.
3.Set configuration switches
SW1:1, SW1:2 and SW1:3 to the
“|” position, and switch SW1:8
(far right of the first bank of
switches) to the “o” position if it
is not already there.
4.Power on the PQ-8. The factory
defaults are restored. The LED
lights labeled “Host Ready” and
“Printer Ready” will blink
continuously, indicating the PQ-
8 is not in operating mode.
5.Power off the PQ-8 and return
configuration switches SW1:1,
SW1:2 and SW1:3 to the correct
twinax address. Switch SW1:8
should be in the “o” position.
