8 Address (ID) AutoDome Easy
December 06, 2006 | F01U032279 Installation and Configuration Manual Bosch Security Systems, Inc.
6 Address (ID)
Each AutoDome Easy camera must have a unique address (ID). When installing multiple dome
cameras using a DVR, it is suggested that the dome camera address match the DVR input num-
ber (for example: Input 1 = Dome 1, Input 2 = Dome 2, etc...). Set a unique camera address
(ID) using the switch selections inside the bubble.
6.1 Setting the Address (ID)
To set the unique AutoDome Easy ID address, do the following:
1. Loosen the bubble’s four (4) tamper-resistant screws using the torx wrench provided.
2. Carefully lift the bubble and set it aside.
3. Locate the SW501 switch.
4. Set the switches based on Table 6.1.
Fig. 6.1 Setting the AutoDome Easy Address (ID)
