AutoDome Easy Installing the AutoDome Easy 13
Bosch Security Systems, Inc. Installation and Configuration Manual December 06, 2006 | F01U032279
Fig. 8.3 Installing the Dome
8. Turn the dome camera to the right approximately 15 degrees.
9. Secure the safety locking screw.
8.1.4 Powering On
When AutoDome Easy’s power is turned on, there is a five (5) second pause before the dome
starts its homing phase. During the homing phase, the camera pans left and right and tilts up
and down. It also adjusts the lens focus. The entire homing phase lasts approximately 40 sec-
onds and displays the following splash screen throughout its homing phase START UP BOSCH
Version 2.0.x.
8.1.5 Installing the Base to a Junction Box
If it is not possible to drill a hole in the ceiling for wiring, it is recommended to use a junction
box (not supplied). To mount a junction box, follow all standard procedures.
To install the AutoDome Easy to a junction box, follow the steps below:
1. Carefully loosen the bubble by using the torx wrench provided to remove the four (4)
tamper-resistant screws. Allow the bubble to hang from the safety tether.
2. Remove the appropriate two (2) (see Figure 8.4) black rubber plugs from the camera
base.
Fig. 8.4 Removing the Plugs from the Camera Base
i
NOTICE! The error message: PROTOCOL IS NOT MATCHED is displayed during the power-up
cycle if switches 9 and 0 are not set correctly.
i
NOTICE! This mounting method does not require use of the supplied mounting plate.
