10 Setting Protocol and Video Format AutoDome Easy
December 06, 2006 | F01U032279 Installation and Configuration Manual Bosch Security Systems, Inc.
7 Setting Protocol and Video Format
The factory default settings for switches 8, 9, and 0 are set for the correct operation. How-
ever, if the camera is operating incorrectly, the proper configuration is the following:
• Switch 8 - set to match the appropriate video format;
NTSC (60 Hz) ON
- or -
PAL (50 Hz) OFF.
• Switches 9 and 0 - set to biphase protocol (see Table 7.1).
Fig. 7.1 AutoDome Easy Camera Function and Protocol Selection Switches
Table 7.1 Dome Camera Function
Table 7.2 Dome Camera Protocol Function
i
NOTICE! The error message: PROTOCOL IS NOT MATCHED is displayed during the power-up
cycle if switches 9 and 0 are not set correctly.
S/W No. ON OFF Function
8 NTSC PAL NTSC/PAL
No. 9 No. 0 Protocol
ON OFF Biphase
Dome Camera
Dome Camera
Protocol Function
Function
Black = ON
