INSert
Command MACHine{1|2}:SWAVeform:INSert <label_name>,
<bit_id>
The INSert command allows you to add waveforms to the state waveform
display. Waveforms are added from top to bottom on the screen. When 96
waveforms are present, inserting additional waveforms replaces the last
waveform. Bit numbers are zero-based, so a label with 8 bits is referenced as
bits 0 through 7. Specifying OVERlay causes a composite waveform display
of all bits or channels for the specified label.
<label_name> string of up to 6 alphanumeric characters
<bit_id> {OVERlay | <bit_num> | ALL}
<bit_num> integer representing a label bit from 0 to 31
Example OUTPUT XXX;":MACHINE1:SWAVEFORM:INSERT ’WAVE’, 19"
OUTPUT XXX;":MACHINE1:SWAVEFORM:INSERT ’ABC’, OVERLAY"
OUTPUT XXX;":MACH1:SWAV:INSERT ’POD1’, #B1001"
MLENgth
Command :MACHine{1|2}:SWAVeform:MLENgth <memory_length>
The MLENgth command allows you to specify the analyzer memory depth.
Valid memory depths range from 4096 states (or samples) through the
maximum system memory depth minus 8192 states. Memory depth is
affected by acquisition mode. If the <memory_depth> value sent with the
command is not a legal value, the closest legal setting will be used.
<memory_length> {4096 | 8192 | 16384 | 32768 | 65536 | 131072 | 262144
| 516096 (HP 16554A)
| 524288 | 1040384 (HP 16555A)
| 524288 | 1048576 | 2080768 (HP 16555D)}
SWAVeform Subsystem
INSert
8–8
