18 Chapter 1 Printer Basics
EN
To Install the Printer Software
Note The following instructions are for Windows computers only. If you
connected a network cable to your Macintosh, see Macintosh
Installation.
1. Place the HP LaserJet 2200 CD in the CD-ROM drive.
2. When the welcome screen appears, follow the directions on the
screen. If the welcome screen does not appear: click Start, click
Run, type D:\SETUP (where D is the letter of your CD-ROM
drive), and then click OK.
3. Click the button next to Install Printer and then follow the
instructions on the screen to install the software.
Note Before installation is complete, make sure that there is a check mark
next to “Print a test page” (when the prompt appears).
In Windows 2000, if the “Found New Hardware Wizard” window
reappears before installation is complete, click Cancel.
4. Click Finish.
5. If the test page printed correctly, installation is complete.
(If nothing prints or if the test page does not print correctly,
see the Troubleshooting Checklist.)
Networking the Printer using Windows Sharing
If the printer is directly connected to a computer using a parallel
cable, you can share the printer on the network so other network
users can print to it.
See your Windows documentation to enable Windows sharing. Once
the printer is shared, install the printer software on all computers that
need to share the printer.
Note Network computers running Windows 3.1x can access the shared
printer, but the computer directly connected to the printer must be
running Windows 9x, NT 4.0, 2000, or Millennium.
