4.
nsta
For more information, see the documentation that ships with the option and see
"Expansion board
option
s (on page 24)."
cific instructions for
eet for your specific server.
I ll the storage controller card.
5. Connect the LED cable to the storage controller card.
6. Secure the cable with the cable clamp.
7. Connect the LED cable to the system board.
For more information, see the label attached to the server access panel.
8. Install the access panel.
9. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
10. Power up the server (on page 6).
Removable media device option
NOTE: This process only represents one installation method. For spe
installing the media device into the server, refer to the installation sh
To install the component:
1. Power down the server (on page 6).
2. Do one of the following:
o Unlock and remove the bezel ("Remove the tower bezel" on page 6).
6).
4.
5.
o Extend the server from the rack.
3. Remove the access panel (on page
Press the fan holder release tab.
Remove the fan holder.
6. Remove the bezel blank.
Hardware options installation 17
