Windows NT 4.0 Configuration
18
2
Preparing to Use the NetBEUI Protocol for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows NT to use the NetBEUI protocol.
Configuring the Printer
Configure your printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default is
active.)
Reference
For more information on how to make the above settings, refer to the Operat-
ing Instructions for your printer.
Configuring a Windows NT Computer
Install the NetBEUI protocol into a Windows NT computer, and enter the LAN
adapter number (Lana Number).
A
Double-click the
[
Network
]
icon in the
[
Control Panel
]
, and confirm that “Net-
BEUI Protocol” is in the
[
Network protocols
]
box of the
[
Protocols
]
tab.
Note
❒
If the NetBEUI protocol is not installed, click
[
Add
]
in the
[
Protocols
]
tab,
and install it. For more information, refer to the Windows NT online help.
B
Change the Lana Number. Click the
[
Services
]
tab, select the
[
NetBIOS inter-
face
]
of the
[
Network Services
]
box , and click
[
Properties
]
.
C
Select the Lana Number corresponding
[
Nbf protocol
]
of the
[
Network route
]
headline, and click
[
Edit
]
.
D
Input “0” as the Lana Number.
Note
❒
If the other protocol's Lana Number is configured with “0”, you must
change the Lana Number a number other than “0”.
E
Click
[
OK
]
.
F
Click
[
close
]
, and close the
[
Network
]
dialog.
G
After confirming the message for restart, click
[
Yes
]
.
Note
❒
When you change the Lana Number, You must restart.
