Remote Maintenance by Telnet (mshell)
67
5
The following example shows how set the protocol for an address.
msh> snmp
number
{ip | ipx}
address
Note
❒
When using the TCP/IP protocol, input ip followed by a space and then
the IP address.
❒
When using the IPX/SPX protocol, input ipx followed by a space and then
the IPX address followed by a decimal and then the MAC address of the
Network Interface Board.
The following is an example of how to configure registration number 3 with
the IP address 192.168.15.16.
msh> snmp 3 ip 192.168.15.16
The following is an example of how to configure registration number 3 with
the IPX address 7390A448, and the MAC address 00:00:74:62:5C:65.
msh> snmp 3 ipx 7390A448.000074625C65
Changing the Password
Use the passwd command to change the remote maintenance password.
Important
❒
Be sure not to forget or lose the password.
Note
❒
The default factory password is “password”.
A
Input “passwd”.
msh> passwd
B
Input the current password.
Old password:
C
Input the new password.
New password:
Note
❒
The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
❒
The password is the same as that used in the configuration of the Network
Interface Board using a Web browser and that used in the NIB Setup Tool.
If you change a password on the mshell, the other passwords are also
changed.
D
Input the new password once again.
Retype new password:
