Filter
Top Products
44 Chapter 2
Operation
Using the Mixers with MMS Analyzers
Operation
To print out an existing AMPCOR table, use the program listed below:
10 dim A$ (1:20) [30]
20 OUTPUT 718; “CONVLOSS 0DB;”
30 OUTPUT 718; “AMPCOR 50 GHZ, 46.1DB, 52GHZ, 46.7DB, 53GHZ,47.2DB;”
40 !
50 OUTPUT 718; “AMPCOR?;”
60 ENTER 718 USING “%,k”;A$ (*)
70 !
80 FOR I=1 TO 10
90 PRINT “Point “;I,A$ (I)
100 NEXT I
110 END
Line 30: Generates an AMPCOR table.
Line 60: % specifies that an EOI terminates the entire statement. “K” specifies that
an
L
F
terminates the individual string entry.
Returned values are in the format where the frequency in Hz is listed first, followed by the
conversion loss in dB. See the following example:
Point 1 50.00000000E+9,46.1
Point 2 52.00000000E+9,46.7
Point 3 53.00000000E+9,47.2
Point 4
Point 5
Point 6
Point 7
Point 8
Point 9
Point 10
Point 11
NOTE For further information, consult the Agilent 70900B
Local-Oscillator-Controlled Modules Programming Manual, part number
70900-90284.