Filter
Top Products
Installation
Note: Take the mixer out of the box and inspect for shipping damage. If there is obvious
physical damage to the outside of the mixer, contact the supplier of the mixer before you
begin installation.
Rack Mounting:To mount CAM8 and CAM8PRO to a 19” rack, lift the unit up to the front of
the rack and secure it to the front of the rack with the necessary screws (not included with
this unit).
A.Turn all mixer Volume Control Knobs [Channel(s) (1), Main (2), and Auxiliary (3)] to zero.
Turn amplifier(s) volume controls to the 7 o’clock position.
B. Connect Inputs.
Connect lead into desired pluggable terminal strip (6) on rear panel.
Press Input Pad Microphone/Line Switch (5) to appropriate position:“in” for line input
or “out” for MIC input. Note that the input from some mics is actually close to line level
(-20 dB) and for such mics the switch should be at “Line.” Set switch for all unused channels
at Line level.The Auxiliary Input (4) is Line level only.
Power
Ratio
0 100
AUX
0 +3 +12+6
+20
-40
MAIN
-12-18 -6 -3
Threshold
Limit
Headphone
-
+
-
+
Cut
Low
1
M.A
BUS
BUS
M.A
CAM8PRO
1
2 3
Page 11 of 32