Filter
Top Products
C. Connect Output: Make a connection between Main Bus Output Terminals (3) and an
input jack of an amplifier. Press Main Output Microphone/Line Switch (2) to appropri-
ate position:“in” for line-level output (0 dBµ) or “out” for mic-level (-50 dBµ) output.
If desired, also connect Auxiliary Bus Output Terminals (1) to a second destination
device. The auxiliary output is line-level only.
D. Connect mixer power supply to an AC power outlet and to the AC Power Jack (4)
(located on far left side of rear panel).
E. Power up mixer:
Press Power Switch (8) to “in” position. [Power Indicator LED (7) will be lit if mixer is
powered.] Set Main Output Volume Control Knob (5) to 2 o’clock. If auxiliary output
is desired, also set Auxiliary Output Volume Control Knob (6) to 2 o’clock.
Power up amplifier.
Note: Mixer will produce signal transients on power up and power down.Always turn the
mixer on first before turning on the amplifier and always turn the amplifier off first before
turning off the mixer.
Page 12 of 32
+
+
+
+
-
-
-
-
G
+-
+-
+-
+-G
MAIN
0dB
-50dB
Off
On
AUX OUT
Phantom
1
3
2