Filter
Top Products
E-11
Basic Operation
Selecting a Tone
Your digital piano has a selection of 8 built-in tones.
There are also two tones that are exclusively for use as low-
range split tones. See “Built-in Bass Tones” (page E-12) for
more information.
* The names of the tones are marked above the keyboard
keys to which they are assigned.
• The GRAND PIANO 1 tone was recorded with stereo
sampling.
To select a tone
1
Press the POWER button to turn on the digital
piano.
• This causes the power indicator to light.
• The “GRAND PIANO 1” tone is selected at this time.
2
Select the tone you want.
• While holding down the CONTROL button, press the
keyboard key that corresponds to the tone you want
to select.
* A note does not sound when you press a keyboard
key while holding down CONTROL button.
3
Use the VOLUME knob to adjust the volume.
• It is a good idea to set the volume to a relatively low
level at first.
* Moving the knob towards MIN decreases volume,
while moving it towards MAX increases volume.
4
Play something on the keyboard.
• Adjust volume to the level you want as you play.
5
After you are finished playing, press the POWER
button to turn off power.
Layering Two Tones
Use the following procedure to layer to two tones, so they
sound at the same time.
1
While holding down the CONTROL button,
simultaneously press the keyboard keys that
correspond to the two notes that you want to layer.
Example: To layer GRAND PIANO 2 and STRINGS
• The tones are now layered.
2
After you are finished using the layered tones, hold
down the CONTROL button and press the keyboard
key that corresponds to the single tone you want to
use.
GRAND PIANO 2
STRINGS
420A-E-015A
Tone Keys
A
0
B
0
C
1
D
1
E
1
B
0
E
1
C
1
STRINGS
PIPE ORGAN
VIBRAPHONE
HARPSICHORD
GRAND PIANO 1
GRAND PIANO 2
ELEC PIANO 1
ELEC PIANO 2