E-12
420A-E-016A
Basic Operation
Adjusting the Volume of Layered
Tones
1
While holding down the CONTROL button, use
the keyboard keys shown below to adjust the
volume of the layered tones.
+ : Raises the volume
– : Lowers the volume
Assigning Different Tones to the Left
and Right Sides of the Keyboard
You can assign different tones to keys on the left side and the
right side of the keyboard.
1
Press the keyboard key that corresponds to the tone
you want to assign to the right side of the keyboard.
Example: GRAND PIANO 2
2
Press the SPLIT button.
• This causes the SPLIT indicator lamp to light.
3
Press the keyboard key that corresponds to the tone
you want to assign to the left side of the keyboard.
• The keyboard is now split between the two tones.
Example: STRINGS
4
After you are finished using the split keyboard, press
the SPLIT button again to unsplit it.
• This causes the SPLIT indicator lamp to go out.
STRINGS GRAND PIANO 2
Split point
■ Built-in Bass Tones
Your digital piano comes with two built-in bass tones.
• Pressing the SPLIT button in step 2 of the above procedure
selects “ACOUSTIC BASS” for the lower range of the
keyboard.
• Holding down the CONTROL button as you press the SPLIT
button in step 2 of the above procedure selects “RIDE ACO
BASS” for the lower range of the keyboard.
Specifying the Keyboard Tone Split
Point
1
While holding down the SPLIT button, press the
keyboard key where you want the left limit of the
high range (right) tone to be.
* A note does not sound when you press a keyboard
key at this time.
Low range
Left limit of the high range
High range
SPLIT
̆
C1
̆
C2
̆
C3
̆
C4
̆
C5
̆
C6
̆
C7
̆
C8
+
-