Filter
Top Products
Using the Mixer
E-39
● Sliders D-4 (1/9/EXT) through D-11 (8/16):
Allow configuration of the following parameter settings in
accordance with the currently displayed mixer setting.
* Operating a slider whose setting does not correspond to
anything on the currently displayed setting screen will
automatically switch to the setting screen that corresponds
to the slider. For example, if you operate slider D-4 (1/9/
EXT) while the master parameter setting screen is
displayed, the display will automatically switch to the MIC/
INST parameter setting screen.
● Slider D-12 (MASTER):
Changes the master parameter setting. Operating this
slider while any screen other than the master parameter
setting screen is displayed will automatically switch to the
master parameter setting screen.
■Setting Operation Example: To adjust the volume
of parts A01 through A16
1.
While the mixer setting screen is displayed, use
the R-17 (u, i) buttons to select one of the
parts (A01 through A08).
2.
Use the R-17 (t, y) buttons to move the 0 to
“Volume”.
• This enables modification of the part volume setting.
3.
Use sliders D-4 (1/9/EXT) to D-11 (8/16) to adjust
the volume of each part (A01 through A08).
• As you move a slider to change a part volume, the
setting is reflected in the value inside the thick brackets
(%) and on the level meter.
4.
Next, to adjust the volumes of parts A09
through A16, press the D-3 (1-8/9-16) button.
5.
Use sliders D-4 (1/9/EXT) to D-11 (8/16) to adjust
the volume of each part (A09 through A16).
When this setting
screen is displayed:
These parameter settings can be
configured:
MASTER Parameters
(page E-41),
MIC/INST Parameters
(page E-42),
DSP Parameters
(page E-41)
Slider D-4 (1/9/EXT):
MIC/INST parameters*
Slider D-5 (2/10/DSP):
DSP parameters*
Sliders D-6 (3/11) to D-11 (8/16):
Parameters of part assigned to
each slider*
Part Parameters
(page E-43)
Sliders D-4 (1/9/EXT) to
D-11 (8/16):
Parameters of part assigned to
each slider*