Filter
Top Products
English
Using Registration Memory
E-37
To recall registration memory bank data
from a file
1.
Depending on where the file is located,
perform one of the steps shown below.
2.
Press the
(REGISTRATION) button so the
lamp below it is lit. This is the
REGISTRATION mode.
3.
If you are recalling a file that contains data for
a single bank, use the
(w, q) buttons to
scroll through the bank numbers (1 through 8)
until the one to which you want to recall the
data is displayed.
• If you are recalling a file that contains data for all
banks, you can skip this step.
4.
While holding down the
(FUNCTION)
button, press the
(LOAD/SAVE) button.
• This enters the LOAD/SAVE mode.
5.
Depending on the type of operation you want
to perform, use the
(u) and
(i)
buttons to display one of the screens shown
below.
To recall a file that contains data for a single bank
To recall a file that contains data for all banks
6.
Use the
(w, q) buttons to display the
file that contains the data you want to recall,
and then press the
(ENTER) button.
• This will cause the message “Replace?” to appear.
• To cancel the recall operation and exit the LOAD/
SAVE mode, press the
(EXIT) button.
7.
To replace the registration data currently in
the bank(s) you selected with the registration
data in the file, press the
(YES) button. To
return to the screen in step 6 of this
procedure without recalling anything, press
the
(NO) button.
• Pressing the
(YES) button recalls the data from the
file into the bank(s) and exits the LOAD/SAVE
mode.
If the file is located
here:
Perform this operation:
Internal area Remove the SD card from the
Digital Piano’s card slot.
SD card Insert the SD card into the Digital
Piano’s card slot.