Compex Systems SX-V Music Mixer User Manual


 
12.4 VCA option
The SX-V modules can be mounted with VCAs instead of plain faders. A DB25 computer type connector allows
control of the VCA with an external DC voltage (for example a video editor). The control voltage ranges from 0 to 5
volts. When used with an external controllers, the faders must be positioned at 0dB.
RETURN TO TABLE OF CONTENTS
13. TIPS ON USING YOUR MIXER
The SONOSAX SX-S has been designed to ensure unsurpassed performance. However, bear in mind that a good
sound recording greatly depends on the dynamics.
We thus recommend the following:
{ Adjust the input gain level at maximum level BEFORE overload, that is with a modulation level between
0dB and +6dB on the modulometer (PFL ON)
{
Input faders should be between 0dB and +10dB.
{
Output faders should be below maximum.
{
Preferably operate at highest possible levels at the first amplification stages or at the mic pre-amp levels.
{ Make sure that interconnection between the SONOSAX SX-S and other equipment is correct and optimal.
{ Optimize operating conditions (location, quality of mic) rather than using the equalizer.
{
Avoid operating with filter at maximum.
{
Switch off unused input modules and make sure that the gain potentiometer is on MIN.
Considering the extensive possibilities offered by your SONOSAX SX-S, this instruction manual may not answer
all questions that may arise during operation of your equipment.
Please contact your nearest SONOSAX dealer for any further nformation.
NOTE:
The specifications mentioned in this manual apply to standard models. SONOSAX SA reserves the right to
modify these characteristicsat any time.
Subject to change without notice
RETURN TO TABLE OF CONTENTS
Back to SX-S Page
12/04/99 LG
Seite 22 von 22SONOSAX SX/S USER MANUAL
26.08.2004file://D:\Z
_
Librar
y
\Webco
py
\sonosax\SXS\sxsume.html