Filter
Top Products
input pre-amplifier.
3.15 Line out connectors
Same Mini-Jacks as INSERT connectors. Independent asymetrical output. One of the contacts gives the
modulation before fader (PRE) and the other after the fader (POST).
3.16 Input module configuration
RETURN TO TABLE OF CONTENTS
4. STANDARD INPUT MODULE
Differences from the newer Power / Mute modules
4.1 Power on/off push-button (red knob)
Each input module is equipped with an ON/OFF switch (red knob) in order to optimize power consumption, if all
inputs are not used.
WARNING:
Do not switch on an input module during a sound recording as this causes a pop.
Optional MUTE push button (gray knob), replaces Power on/off: supplies constant module powering. The gray
knob turns modulation on and off silently ( no pops).
4.2 30 dB PAD (Input attenuator)
To be switched on when the OVD LED lights up at minimum gain control setting. This happens, for instance, when
high level input sources such as a tape recorder or a condenser microphone at high acoustic levels are used.
4.3 GAIN
Seite 8 von 22SONOSAX SX/S USER MANUAL
26.08.2004file://D:\Z
_
Librar
y
\Webco
py
\sonosax\SXS\sxsume.html